Counting matching models…
These are a pair of well-fitted mounting brackets to wall-mount a Mayflash F500. Modeled in Onshape, they match the angles of the body of the joystick and hold it flush against the wall. I printed in PETG with 0.2mm layers, but PLA should…
Did not like this thing flying around willy-nilly on my desk. Should snap into place around the bottom of the adaptor. Print with PLA+ or similar for rigidity and secure to desk with M3 screws
Usage Print 2 pieces (no supports, PLA or PETG) Slide onto either end of the sensor bar with center stand removed Orientation matters! Set on top your gaming monitor
Vertical stand for Mayflash F500 Fight Stick (and maybe F500-Flat) Recommend using 3 wall loop, 15% infill, and Gyroid pattern.Vertical stand for Mayflash F500 Fight Stick (and maybe F500-Flat) Recommend using 3 wall loop, 15% infill, and…
I couldn't find anything for this specific adapter, so I decided to learn a bit of 3d modelling and make one myself. You still have access to the buttons on top, you just have to slide the adapter out a bit. Might add a small lip to the…
Manually paint the support on the hinge area as well as the latch. Make the layer height as small as possible.
Fixed cables are a PITA, so I wanted to make the USB cable on my fightstick detachable. I used a dremel to widen the existing notch that was used for the original USB cable. My wishlist of improvements for this are as follows A top cover…
