Counting matching models…
Armrest latch for Mitsubishi Pajero sport (K90). Recommendation: Material: PETG Layer height 0.15 mm Infill: min. 50 % gyroid
Print approx. €0.14–€0.18 excl. taxPreliminary estimate for PETGSource material: PET
It is a simple 3d model easy to print in up-right position on standart 0.2 layer height prints in about 1 hour
My first detailed model created based on provided measurements, as a request. First version has been printed, but not yet tested. I printed the matching male part from plabs.cz (Thank you!) slightly modified to make rounded part 8mm wide.…
This is a stand for remote controller for AC. remote is from mitshubishi AC. Dimensions of the remote are 55x130x20mm
My Mitshubishi T200 backpack cutter is too old to find/buy a new part so i had to make new throttle lever. Maybe are there a few things to improve but throttle lever is doing its job. What to improve: holes should be little bit smaller >…
This is a stand for remote controller for AC. remote is from mitshubishi AC. Dimensions of the remote are 55x130x20mm
