Counting matching models…
remix of : https://www.thingiverse.com/thing:4804448 YOU HAVE TO PRINT IT UPSIDE DOWN! (at least i had to) rotate it 225° in the slicer and use support settings below. after slicing it should come out like in the picture. i sliced it in…
UPDATE: 20261002 I have been swamped with work and unfortunately haven't been able to dedicate the time to working on this project. However, my schedule has freed up and I should be able to get the final release version out by the end of…
PRO TIPS: Wait a few minutes after printing is finished before taking your 🗿bookmark off the hot bed (this will help prevent bending and warping of the thin bookmark). 2. If you're not using my print profile on MakerWorld, ensure that the…
Print with original settings Only one 016 o-ring for the Collet, I removed the others
replacement part for Birdy bike Kamoya rear suspension made of TPU adjust the stiffness by changing the infill density
Birdy Kamoya Front Suspension rubber replacement
This is the same Umoya posted by WaFfLe and ZafC with the threaded collet removed and replaced with a 3rd o-ring. Made this to fit a Lynx with an 18" barrel where there isn't enough barrel to use a collet. This will slip inside the shroud…
This is a PLA (doesn't matter what u use as long as it ain't TPU) Samoyad, I find the procsess of snaping on the eye quite satisfiying, but sometimes it breaks, my first prototype was 1% infill, but my second just barly work at 100%, but…
Moya - Farscape TV series ship (cut for easier printing) I scaled this model to 500mm in length then placed a cut at 125mm intervals from center so that I may print this sweet model without supports Print Settings Rafts: Doesn't Matter…
1.4 with the sharp steps removed for less supports... chucked on a threaded lock so a resized akasha cover could be used. I believe WaFfLe will fix the steps up himself in the next revision :)
