Counting matching models…
Two concentric squares to check if your buildplate is level or warped. Fast to print. Use this test print to check if your printbed is level and adjust your first layer height. The outer square is 150mmx150mm. Make sure to take a look at…
Photo frame. Inside you can fit a 10x15 cm photo. Category: Art
to store mini stuff under the desk and free up some space on it
Passt viel rein, lässt sich stapeln
A simple vented funnel I printed to help with mower oil changes. 150mm across, 150mm tall, 20mm across at bottom. Wall is 3mm thick. Print wide end down, no supports needed. Fusion 360 source and .STEP file included.
Do you like this design and want to give a Tip for it? Do it here Hey I designed this Ghost S1 foot for a more efficient Ventilation of the Ghost S1. It's optimized for Noctua NF-A12x15 PWM fans and seem to work very efficiently. Since I…
Mount can be clipped between two 16mm rods. If needed, use zip-ties to secure it. In my case, i don't need any zip ties for holding 2 x Arctic P14 FANs…. The clip it designed to be used with standard 15mm X 15mm aluminum profiles Parts…
resize to 10% i dont know why so big print fit test first if cant fit = try to incresss hole horizontal expansion (mysetting 0.5) my thrid party logitech ear pad size is 105x85 but i have 3 size for download 110x90 105x85 100x80
Needed a mount for my tenda mx15 to get it as high as i could in the basement. its a tight fit but it wont be going anywhere.
materiał pla drukowany bez podpór
Proven working: PLA 0,15 structural Snug supports everywhere (organics do work but are a pain to clean up) Remember to remove supports on the inside
Proven working: PLA 0,15 structural Snug supports everywhere (organics do work but are a pain to clean up) Remember to remove supports on the inside
A simple bracket to mount a shelf, hanging under an existing shelf. I wanted to utilise some of the dead space under some of my existing shelves, so a suspended shelf seemed like a good idea, no? Just for light-weight stuff - say, 3D…
Enjoy a photo of my tiny old orchid. 90mm diameter x 150mm height Recommended printing settings: Material: PETG (I used a blue-translucent one) Layer height: 0.2mm is fine Infill: 0%-15% infill Perimeters: 2-3 Outer brim: 10mm width,…
