Counting matching models…
Hi guys, welcome to my new Nanolongrange FPV drone design! This is the 4th and most sophisticated iteration. The design builds on my previous completely 3d printed frame NLR35. The goal was to make it lighter, more powerful and yet fully…
Hi guys, welcome to my new Nanolongrange FPV drone design! This is the 3rd iteration, you may know the previous versions https://www.thingiverse.com/thing:4743497 and https://www.thingiverse.com/thing:4818009 This time, the design aim was…
You can use the same parts as for the NLR35. You can get the O4 air unit <a href="https://www.banggood.com/custlink/DvGS4l0mPD" target="_blank">here</a>
I really like this project! Had to wait quite a while for the parts coming from China but when everything had arrived the build was done in some hours. It does not have much power but it flies quite good and you have a lot of stick time…
The camera plates in the original design are 15mm apart while nano cams are usually 14mm wide. These spacers can be printed out of a soft squishy material (TPU) to fill up the gap. Category: R/C Vehicles
This is a small collection of mounts for the #NanoLongRange DIY drone project. The mounts include: Insta360 Go (version 1) Beitian BN-180 GPS module Combined Insta360 Go and Beitian BN-180 GPS module You can view my flight video using a…
Simple antenna strap for the Nanolongrange EVO quadcopter to make sure the antenna stays out of the props and is always upright This mounts to the battery tray with two M2 nylon screws Printed in Sainsmart TPU
Simple antenna strap for the Nanolongrange EVO quadcopter to make sure the antenna stays out of the props and is always upright This mounts to the battery tray with two M2 nylon screws Printed in Sainsmart TPU
