Counting matching models…
I re-made this model to be able to adjust the Nanostation even more then the previous model. A wider range to be able to point the Nanostation makes it easier to mount it to the wall one time and not have to worry about it again. Printed…
This 3D print model provides a secure wall mount specifically designed for the NanoStation Loco M2, but it may also be compatible with other models. The mount allows the antenna to be rotated horizontally by approximately 100 degrees,…
Simple wall mount brackets for the Ubiquiti Nanostation / Loco M2 M3 M5 AccessPoints Print Settings Printer: Prusa Mini+ Rafts: Doesn't Matter Supports: Doesn't Matter Infill: 20% Filament: BASF Ultrafuse PLA Grey Category: Computer
This is an outdoor wall mount I made for a couple of Ubiquiti NanoStation AC PtP/PtMP bridges so I could angle them up/down and side/side. The mount it comes with is a flat wall mount. PLA I printed the posts on both mounts at 100% infill…
Remix of original model, where gap for metal clamp, which came with Ubiquiti antenna, was too narrow. Print settings: Material: ASA / ABS (for outdoor use) Layer hight: 0.3 Wall Line count: 2 Infill: 15% Supports: Yes Scale of model: 45%
2-axis wall mount for the Ubiquiti NanoStation AC loco wireless bridge. It require support for accurate printing. Please use PETG or similar material if exposed to sunlight. Required accessories: Superglue 1 x M3 brass threaded insert 1 x…
I needed a stand to get these running in a day, so I thought a kitchen roll holder would be perfect! I made it hollow to save time and material. printed in leftover spools of wet petgCF. Bambu A1 doing great! 0.6/0.42
Mount for nanostation loop m5. Printet in ASAX. Infill 40%
This is my own version remix for the Nanostation Wall Mount. I have scaled bigger to accommodate M5 screws plus be able to use it with poles 1/2" Nanostations are used to make Point To Point or Point to Multi Point wireless connections.…
An adapter for older Ubiquiti NanoStation Wall/Window Mount (NS-WM) as a mount for the newer NanoStation AC Loco (NS-5ACL-US). Category: 3D Printing
Mount Arm for Ubiquiti NanoStation LocoM5 with a ±8° of tilt adjustment. The sleeve in this design is a loose fit over the arm. If mounting outdoors, this might need to be affixed with adhesive, or a screw. The sleeve allows about 10°…
This is the wall mount for nanostation M5 loco, the dimensions are 100mm to 150mm, the antenna attaches to the mount with zip ties
Mount Arm for Ubiquiti NanoStation LocoM5 with a ±8° of tilt adjustment. The sleeve in this design is a loose fit over the arm. If mounting outdoors, this might need to be affixed with adhesive, or a screw. The sleeve allows about 10°…
This is the wall mount for nanostation M5 loco, the dimensions are 100mm to 150mm, the antenna attaches to the mount with zip ties
