Counting matching models…
This is scope covers for DNT Optics TNC225R. This model is open sourced, originally created by me in OnShape (free CAD): https://cad.onshape.com/documents/adb0050f873ff66e82018843/w/f74eee5a9668a49b2e15d0b2/e/ac6ac35e0cebbabe29aa26b1 No…
This is an update to my aux-jack replacement bracket for aftermarket radios for the NC2/NC3 MX5 Miata. Instead of putting the purchasing flush mount usb extension for the cigarette lighter, I wanted to reuse the aux jack port for my USB-C…
Spooky season is back, and what's better than enjoying it with your Miata ? I made this set of fangs for my NC2 model (first facelift 2009-2012) as I couldn't find any good model for it. I first 3D scanned the front grille, then modeled…
This is a remix of the aux-jack replacement bracket for aftermarket radios for the NC2/NC3 MX5 Miata. Instead of putting the purchasing flush mount usb extension for the cigarette lighter, I wanted to reuse the aux jack port for my USB-C…
Based on my Pi Zero case https://www.printables.com/de/model/681540-pi-zero-case-1st-2nd-gen I've made this case for ENC28J60. The width is the same to the Pi case, length and depth are different.
This is cover for ENC28J60 ethernet module. Original project page https://www.thingiverse.com/thing:5434883 Remixed from https://www.thingiverse.com/thing:4589050 OpenSprinkler 3.2 cover is here https://www.thingiverse.com/thing:4639621
I designed a replacement lid for the Ninja Creami Breeze NC201UK. Measurements taken very accurately from the official lid Printed in PLA on a well calibrated printer it gives me a really nice snap fit onto the pint. Category: Replacement…
I wanted to keep the filament into the enclosure 2.0 of my VCore 3.1 300x300 and this is what I came up with. With Eva3 and a 4028 part cooling fan the maximum spool width is 70mm per Ø200mm. It has to be used in combination with a…
This is to stop the 8mm bolt head spinning in the T slot of the work surface if you bought a version with the clamps. 7.4mm hole and 14mm across flats (nut_holder.stl) Makes it a lot easier to use the wing nuts. Added a 6mm version upon…
The bracket uses two of the holes holding the shield together and slots into the plastic part above it. Not very sturdy but should work fine. Assembly The mount is designed for M2 inserts for mounting the plate. E-Mail me at…
Note: I noticed after I made one that it partially blocks the 40mm fan envelope. I’ll redesign it in the next few weeks so that it clears the fan envelope. There are now 4 files for 2 parts. Each part has an IGS and an AMF file. Some…
A simple protective cover/case for the Mobilink TNC series. Made to protect the button from being accidentally pressed to turn it on/off by mistake. Holes made to allow light from the LEDs to be visible, and make it easy to remove the…
A sturdy 2-inch hydroponic net cup designed to hold a standard 1.5-inch rockwool cube. The square 38.8 mm pocket grips the cube so it doesn't spin or fall through, and the open slotted sides and bottomless design give roots plenty of room…
This is an update to my aux-jack replacement bracket for aftermarket radios for the NC2/NC3 MX5 Miata. Instead of putting the purchasing flush mount usb extension for the cigarette lighter, I wanted to reuse the aux jack port for my USB-C…
