Counting matching models…
Onkyo AV receivers tend to fail after some years of usage. Most of the time the HDMI board is faulty. Usually, some of the capacitors went bad or there are bad solder joints at the DSP chip. The capacitors can be replaced and a bad…
Print without supports. Exactly as shown in the photos. Customizable via Fusion 360
There seems to be no file online of these feet. I modeled them after the feet i found on a Pioneer vsx90 and a Integra 2.4 This is an OEM replacement.
Needed a higher feet for the ONKYO 746 receiver for a better air flow. This has fixed the overheating issue within the cabinet.
After having moved, I no longer had a wall behind my couch to mount the rear speakers of my Onkyo 5.1 sound system (model SKR-548), therefore I did that. It's made to be printed as is, without support. Fits on a CoreOne bed. It is fitted…
Battery cover door for Onkyo RC-294S remote control. Printed in PETG for flexibility at 15% infill using organic supports for the build plate.
50mm OD 27mm Tall Volume knob for 6mm potentiometer shaft.
A light burnt out in my Onkyo amplifier. In my case - the “Super Servo” one. The original part was flexible, so after many iterations I have landed on this particular design which can be printed in PLA and is just flexible enough. It…
I needed a replacement foot for my AVR that was shorter so I could fit it in the cabinet I'm using. This foot does not include a recess for any rubber pads but will work with the stock screw used in the Onkyo TX-NR696's stock feet. PETG…
