Counting matching models…
Tested and working, .327 caliber speed loader for the Ruger SP101. Material: PLA Requires super glue inside hex cap for the final assembly. Updated design, as of 6-22-25 No supports needed, easy assembly. STEP file included for mods. A…
Stackable dual HDD tray for the Antec P101/Silent This can be used to replace the 5.25' drive bay with another 2 HDDs.
One of the door retainer clips on my P101S broke when I was trying to close it. This should be a drop in replacement. It prints perfectly flat on the bed.
I have a NAS server with the Antec P101 Silent Case. When the side panel clip broke I made this one to raplace it and figured, why not share with others that may be searching for this too.
A 3x1x6 Units Gridfinity Base for Noga SP1010 Deburring Set Holes are already with offset. If your printer tolerances are out of way and the pins don't fit, a 3.5mm (ideally 3.4mm) drill bit should do the job.
Simple mount for a third SSD for Antec P101 Silent. It uses two mount location that were (probably) intended for a HUB of some sort. It needs two short ish mount screws to the mainboard tray. The screws must be short as you could shor the…
Printable HDD Tray for the same case to extend it to 10 HDDs: https://www.printables.com/model/1423100-antec-p101-hdd-tray I saw one that had the ssds in vertical, but I made this one to take advantage of the natural airflow of the case…
This is an ammo box for 9mm rounds loaded in moon clips for the Ruger SP101. The STL files include the box and two lid versions. One with writing, one plain so you can use as is or customize. I will make alterations on request. The fourth…
The LP101 end cap is designed to provide a clean and professional finish to aluminum LED strip profiles. It is typically made of durable plastic and fits snugly onto the end of the LED channel, covering exposed edges and protecting the…
A laser cut frame for a 3D printer, and a spool holder made of two laser cut holders and two 3D printed mounts.
The switch on my drill press died. Discontinued part. Yeah, I could buy a used one on eBay for $25, but that's no fun. Found a heavy duty DPST paddle switch on Amazon. I could have printed it black, but grey ASA was already loaded.
I have a NAS server with the Antec P101 Silent Case. When the side panel clip broke I made this one to raplace it and figured, why not share with others that may be searching for this too.
Stackable dual HDD tray for the Antec P101/Silent This can be used to replace the 5.25' drive bay with another 2 HDDs.
Printable HDD Tray for the same case to extend it to 10 HDDs: https://www.printables.com/model/1423100-antec-p101-hdd-tray I saw one that had the ssds in vertical, but I made this one to take advantage of the natural airflow of the case…
