Search results: pullup

Counting matching models…

Printables

ergonomic pullup grip

ergonomic pullup grip to do lying easy pullups attach to any rope or band

Order a print of this model

Printables

ergonomic pullup grip

ergonomic pullup grip to do lying easy pullups attach to any rope or band

Order a print of this model

Printables

Pullup bar door frame spacer

spacer for door frame pull up bar so that the frame gripper sits parallel with the wall

Order a print of this model

Printables

Base for door-frame installed Ultrasport pullup bar

When using my pullup bar, an Ultrasport 2-way Pull-Up Bar, it constantly slipped down as i was using it, even though i had it expanded by quite a lot. I noticed the rubber that comes with it is quite hard, so I thought of making this…

Order a print of this model

Printables

Pleasant Permanent Pullup Bar

Requires: One 42mm diameter pine dowel(length to preference). Two 3D printed wall brackets. Two 3D printed pole endcaps. Six 10g 45mm, self-embedding timber screws. Installation: Brackets: Pre-drill timber screws through PLA slowly to…

Order a print of this model

Printables

Pullup Handle

To allow better grip for pull-ups on a horizontal beam we made this handle. Make sure it is savely screwed to the beam bevore using it Printed in PLA with 6 outline, top and bottom layers and with 30% infill for maximum strength.

Order a print of this model

Printables

Rotating pullup bar

Printed in pla, 100% infill. No support needed. I added source files in step and f3d format if your pipe have very different dimensions. Bearing should sit tight in “bearinghousing” (I pressed mine with woodworking clamps and piece of…

Order a print of this model

Printables

Replacement Pullup Bar Grips (1 Inch Diameter)

The foam grips that came with my doorframe pullup bar deteriorated pretty quickly after buying it so I decided to use it as my first 3D modeling project. These photos are from after about a year of active use. So, they held up pretty well…

Order a print of this model

Printables

PullUp Bar swing clamp

Simple, yet robust clamp for fixing the snap-hooks in place on the 28mm Pull-Up bars. Mine is Aurapol Natural PLA, .30 Draft, bottom layers up to 3mm are solid, rest is the 4 perim / 30% square infill. No supports needed in “bridge” mode.…

Order a print of this model