Counting matching models…
This raddle is designed to fit over the last frame on your loom for warping back-to-front. It prints in 6" sections that dovetail together to whatever length you require. There are 4 slots per inch, so on a Norwood loom 8 slots will feed…
It uses the USB-C cable delivered with the Headset for Charging.
A 48cm/19" raddle/warping bar with 12 pegs. With a warp retainer bar that can be clamped on - we used a bulldog clip.
I made this to replace the slide on jaw protecters on the 6" Irwin clamps. (Joint Bridge-Irwin) I am also including the joint bridge that is flat top if you want to modify to your own clamp. (Joint Bridge.stl) Printed on Ender 3, PLA…
Cut out most of the core material and just kept the small 2.5mm holes at the end. This way larger awls that wouldn't fit the og can now be used. Bottom of craddle is unchanged and only uploaded here for convenience, you can also just use…
I was annoyed having to use the akward default case for my Airpod Max headphones. If it didn't use the case then my headphones would drain its charge. Designed this for storing them on my desk and in sleep mode. There are even notches in…
This raddle sits over the back beam on a Norwood loom. The pegs are spaced at 2" to match the spacing on the Norwood segmented warp beam to cleanly align your yarn with the beam. Print in upright orientation without added support…
I wanted to have some kind of charging craddle to charge my IQOS 3 Duo while it is in the Folio. Here it is! HINT #1: The charger plug is not centered, as the folio is thicker on one side! May work without the folio, but that's not how it…
Phomemo D30 holder for openGrid. Attached with a openConnect connector. Print the D30 holder (I printed it vertically with supports at the bottom) and one set of the openConnect snaps. You can use other snaps, I've just included one set…
Cut out most of the core material and just kept the small 2.5mm holes at the end. This way larger awls that wouldn't fit the og can now be used. Bottom of craddle is unchanged and only uploaded here for convenience, you can also just use…
Phomemo D30 holder for openGrid. Attached with a openConnect connector. Print the D30 holder (I printed it vertically with supports at the bottom) and one set of the openConnect snaps. You can use other snaps, I've just included one set…
