Counting matching models…
I built a bunch of modular audio gear boxes for rackmount equipment. I designed these feet and "feet receivers" to be installed on the boxes so they would stack securely. You'll find the files for the feet, receivers for the top of your…
This model is the receivers for SMILEY Talon Version that have been slightly modded so that the hand guard and breech housing can fit in them.
Tested on jvc jr-s401. Should work on all other models that use the same knobs. I printed without support with the round flat faced “front” of the knob facing down, like in the set of 5 model. Printed on creality cr-6se. Model is in mm.
A hook to add different heights of adjustment on your outdoor shades/blinds. no supports needed, PETG recommended.
I have modified the rugged box to be able to fit 4x LD Systems MEI1000G2 receivers as well as 4x AA batteries, there is a small 5th slot which you can use the metal clip at the back of each receiver to clip onto the dividing walls so they…
A friend of mine bought a savage 23 which was drilled and tapped for some obscure or possibly homemade mount, this is a simple mount that uses the holes on the side of the receiver to mount and allows use of standard picatinny rings. I…
Maximize your receiver setup with a one-of-a-kind 3D print. Engineered for precision and flair, The Audio Mount Pro is a must-try print for enthusiasts! Introducing the Audio Mount Pro, a remarkable 3D printed solution for mounting up to…
I’ve occasionally driven my amplifier into protection mode when playing at very high volume levels with low-impedance speakers (down to 3 Ω) at full range. This usually happens during longer listening sessions, as the amplifier tends to…
The best way to mount up to 2 URX-P40 Sony audio receivers both facing the cameraman, very useful to monitor the battery and audio levels.
Print in an upright position for increased groove stability. Check out my other fischertechnik compatible parts .
If you are using 2 audio receivers for wireless audio while filming with a mirrorless camera you will find it pretty hart to find 2 places where to attach the receivers and also be able to monitor them while filming. This easy to print…
Receiver bracket with a width not exceeding 12 millimeters
Best if printed in TPU or nylon
Project Overview: 2S LiPo High-Current Power Box with two Sbus inputs This circuit is a high-performance power distribution system designed for large-scale RC models. It manages power from dual batteries to drive up to 16 High-Voltage…
Project Overview: 2S LiPo High-Current Power Box with two Sbus inputs This circuit is a high-performance power distribution system designed for large-scale RC models. It manages power from dual batteries to drive up to 16 High-Voltage…
I built a bunch of modular audio gear boxes for rackmount equipment. I designed these feet and "feet receivers" to be installed on the boxes so they would stack securely. You'll find the files for the feet, receivers for the top of your…
