Counting matching models…
These are cases for the active Y/C adapter made by the Retrocastle store on aliexpress. With this adapter you can connect your Mister FPGA to a CRT TV through either the composite or the S-video port. The adapter is sold without any…
Thanks to @meltmidori for the original design. It covered the audio jack so I made a slimmer version that allows you to still access it. Case used in the photos is here .
These are covers needed for the 2024 RetroCastle I/O board and the pieces that stick out of the case, including the MicroUSB Bridge and HDMI Ribbon Cable adapter to the Video DAC.
This is a case for the RetroCastle General VGA (15khz) to Composite/S-Video Adapter for the MiSTer FPGA. The PAL/NTSC switch is accessible and labelled from the top of the case. It requires 4 x M3 10mm to 16mm screws, whatever you have…
Required slicer settings: Disable supports - the base was designed to be able to be printed without support, also, there's holes inside it (the "tunnels" for the zip ties) that could be blocked depending of how supports are configured on…
Required slicer settings: Disable supports - the base was designed to be able to be printed without support, also, there's holes inside it (the "tunnels" for the zip ties) that could be blocked depending of how supports are configured on…
Slimmer yet sturdy minimalist case, omitting switches/USB port access. Secured with two M2 screws (5 mm length suggested).
Remix of the covers for the HDMI ribbon cable connector for the dual RAM model of the Mister FPGA from Retrocastle. The original creator of the covers is Kuro Houou and here's the link for his design:…
