Counting matching models…
This is a mount so I could easily fit a Cardo Spirit HD intercom to my Shoei GT Air II motorcycle helmet using the SRL2 standard fitting system. Shoei helmets are built to take their own intercom system but it's very expensive and I…
I own a SHOEI GT AIR II motorcycle helmet ( I love this helmet ), and was frustrated with not being able to easily mount other communication devices due to the SRL2 mounting points take up room on the helmet rim. I decided to see if I…
Another remix of Pfelpensson's GAZ66. This time an electronic intelligent system for searching and positioning of enemy radio signals in the range of 500…9000MHz and a depth of up to 70km. Two version of the vehicle can be printed – on…
GEPRC GEP-RL2 frame parts (GEPRC Rocket). I'm flying a GEPRC Rocket lite with the prop guards removed and 2.5" props. The parts have some improvements over the originals but it should still be compatible with props guards and 2" props.…
Keeps the Sharpener, Angle Support and extra grinding disks organized and housed in the Original Box the Sharpener came in. Print with no supports
knife holder for my robotic lawn mower . this is the first version. known issues: to much filament used holders are breaking off today 18.04.2018 testrun of V1 with broken holder first run was ok V2 changed to print it in two parts you…
I was really disappointed by the Sena SRL2 Speakers that fits in my Shoei GT-AIR 2 helmet. The only way to hear anything through them was with Audio Boost on which in turn made the audio distort. so I took some 50mm speakers of my old…
Simple monitor shelf modelled to fit the angle and front lip on the BenQ RL2755-B (or ZOWIE RL2755) gaming monitor. Split into 4 sections for easy printing and modular setup, there is Left and Right end pieces (with a rear lip as well as…
After seeing JuM1697 's model and reading the discussion about the angle, I created a revised version to sharpen the knives at a 10-degree angle. The raised section should if you clip the Hole2 with the other side in it result in a…
I was really disappointed by the Sena SRL2 Speakers that fits in my Shoei GT-AIR 2 helmet. The only way to hear anything through them was with Audio Boost on which in turn made the audio distort. so I took some 50mm speakers of my old…
Pin wrench for 2.5 pins (just use 2.5 nails) made to fit bottom cap of x-fusion sweep rl2
If you have an RL200 & have used it for more than 2 months then you too will know the joys of taking the extruder covers off for the umpteenth time. I got so peeved I merged the two covers to try & make life easier, it did help alot so…
