Counting matching models…
These are simple plates to block off the area where the mirrors were if you remove them for track days or bar end mirrors. The countersunk version is meant to be used with 6mm countersunk fasteners. The buttonhead version is meant to be…
If you remove your passenger pegs you can bolt this in place to cover the holes. Needs 8mm socket head bolt to hold in place, the stock passenger peg bolts are too long and won't work. I suggest printing this upside down with supports,…
This is a block off plate for the front turn signals on a USA-spec Aprilia RS457. If you remove the front signals you can bolt this plate in place of the missing stalk using a 6mm nut. These do not have to be very tight, just enough to…
This is a RAM mount that attaches to the steering stem nut. It uses an 8mm RAM ball that is sold/intended to be used with the handlebar clamp. An STL for the RAM ball and shaft are not included, I used one I had sitting around, but may…
This will cover the hole left in the fender when you remove the reflector. Attach with a 6mm nylock nut over a washer. Be careful not to over tighten, it only needs to be tight enough that it doesn't spin. Blank version has nothing on the…
The main sections bolt on where the passenger pegs are supposed to go. The rear brace needs a small hole drilled in the tail section for the bolt that holds it on. I printed this with a carbon fiber infused nylon filament. I printed this…
Ok let's be honest, when it comes to fastening bodywork and other bits, Aprilia makes some pretty dumb choices. For example - if you try to remove the mirrors for a trackday or whatever, you will discover that the nuts drop down behind…
