16 models
Printing Case and Lid: PETG or PLA recommended 3 Perimeters .20 Layer Height 10% Grid or Rectangular infill Inserts: TPU or other flex recommended 0 top and bottom layer 10% gyroid infill 2 perimeters 2-Feb-2026 Added Case with Handle…
Inner Ring has been updated to make mounting substantially easier. Also the wheels are (and always were) compatible with Injora brass inner beadlock rings. Not to be confused with their inner wheel weights. [Rear wheel half has been…
Here are some basic rear links for the SCX30 to increase your wheelbase by 5mm. These probably wont fit your stock bodies without modification obviously, but can work will on custom and fenderless rear bodies like the one shown (coming…
Scx30 Wheel Weights. No modifications required to the stock Scx30. Prints quickly and without supports. If printed with PLA, each wheel weights approximately 1.3 grams. Denser filaments might be better for making them heavier if needed.
Front mounts. Couple different heights. Rear is adjustable. Trim rear as needed to fit. I'll revise where needed and update files. Comment/Message with any questions/advice.
After making a set of functional beadlocks for stock tires I adapted them to fit the larger RC4WD tires. These work and fit like my previous beadlocks, and I've copy and pasted most of the assembly info down below incase you havent seen…
I needed/wanted a small little mount that lifted the truck off the wheels slightly but was still compact, so I drew this up. the part of the mount that contacts the truck is slightly wider than the skids as it is intended to be used with…
A second version of SCX30 blades. I extended the frame stop by the shock mount to prevent overcompression and jamming up at the frame. Same geometry as the early version except for that change. These work in PLA or PETG. But they are…
Make an awesome gooseneck trailer for your tiny truck.
Replacement wheel hex for Injora SCX30 D19 wheels.
This model took me F O R E V E R to make. The sizing, the scaling, the making in general, the testing. This was hard work and it took me a whole roll of filament on JUST TESTING. So please, enjoy this model, post makes, like, and most of…
Just another iteration in the SCX30 design process. The shock mounts are countersunk 1mm for better angles on the struts. I'm printing these in PLA at 0.16mm layers. I'm using manual tree supports for the rears, with PETG interface for…
This is a scaled down version of my existing 1:24 scale RTT using the dimensions of the Thule Approach M IRL scaled to 1:30 to be used on the SCX30 or similar sized vehicles for a scale overlander look. Printed in PLA using 8% infill to…
a bumper for the scx30
this remix fits a MEUS remote. I have yet to test it. also the vehicle storage area is maximized. i also included a filled in blank. happy remxing!
