Counting matching models…
------------------------------------------------------------------------------------------------- UPGRADED PARTS AVAILABLE! Click the link to get to V.2 of this part:…
Wanted to use in my 10-inch rack setup since I need the extra space under the Pi for an errant tall PoE HAT in a 1U rack below where this rack will be installed. I subtracted some of the material from the print model surrounding the…
Print with the wing on the bed.
A mounting plate for the TP Link TL-SG105 E network switch that allows you to attach it to a flat surface using double-sided tape. I recommend using PETG or another strong filament to keep the screw heads from breaking off. Print with…
For the TP-Link TL-SG105E. Air vents not coverd, all ports/connector remain useable, all LEDs visible.
This bracket is designed to mount a Netgear TL-SG105E 5-port network switch on a Multiboard grid using the versatile Multiconnect connector system by DavidD . Print the Model The clearances are optimized for a tight fit and work well with…
Minimal remix for the TP-Link switch. Fix M3 nuts into the place as on the photo, screw in the bolt to the exact height and attach the switch.
Little remix to mount a TL-SG105E in your 10" Rack. You have to remove the two little screws under the switch. After that you have to slide the switch in the mount until its flush with the front. The last step is adding two M3x6mm screws…
This model has tight tolerances. I would recommend printing it from PETG due to the heat that might be produced from the switch.
