Counting matching models…
Adhere a neodymium magnet of 2.5 mm or less in thickness. I recommend 13mm diameter, 2.5mm thick magnets from Daiso. 厚み2.5mm以下のネオジムを接着してください。 おすすめはダイソーの直径13mm 厚み2.5mmの物です。 The model is modeled for V3 Plus from 0 based on the model in the…
The model that Mikyleee used was nice. I liked it, however, I wanted something that may stay in place as I did a print today and man can the X1 move. Figured I would try mounting some small magnets and see how it holds. I will be printing…
Used Shapr3d to modify.
Simple shute to add marbles to the track. You can try to print it without support, but I did it with a little organic support just under the open part of the shute.
Remix of the model by Ink. This adds a steeper slope to reduce the chance of the filament getting stuck at the top. This also creates more volume for waste in the tray.
Instead of screwing right through the top hole, screw in the screw first (I recommend a replacement M3x10/12) and leave a gap for the slot in the shute. the screw at the bottom aswell as the top slot, It holds in place pretty well.
designed to hold 5 joe shute skirts including weighted skirts for tuna fishing. can be used to hold a great number of other things as well. the lid slides in and clicks in place. holes in cover and box are to drain water. tubes are 1.25"…
U need Ø10mm or less diameter three magnet. Use adhensive to merge it.
Print the shute with support (I prefer the snug since it's easier to remove). I used a TPU from Overture, 95A, for the seal: https://geni.us/4Qa3O (obs: affiliate link, but you don't pay more if you buy from this link). Consider also…
Shutter made primarily to fit Edgar's Kech 4x5 scalable camera, but it should works with other 4x5 also. There is only manual operation mode, no shutter speed other than B. I've put cable release and spring on the lever in mine, so it…
You can try to print it without support but I used a little to support the top of the arc.
It is a badminton shute i made as a gift, when slicing you best scale it al the way up. It was made verry small as it was my one of my first models ever made.
Adhere a neodymium magnet of 2.5 mm or less in thickness. I recommend 13mm diameter, 2.5mm thick magnets from Daiso. 厚み2.5mm以下のネオジムを接着してください。 おすすめはダイソーの直径13mm 厚み2.5mmの物です。 Category: 3D Printer Parts
