Counting matching models…
Ikea Skurup lamp comes with table and wall mount, but not rotating base. This makes Skurup to rotate. Printed pla 25% infill and 3 perimeters. Uses wall mount and metric nuts and bolts. Assembly picture has bom.
A cable clip for your Ikea Skurup standing lamp. Print with 3 walls for best results
Needs a well calibrated printer. Try to fit at 0.2 layer height, it worked for me. Screw and unscrew it few times until the screwing movement is smooth enough. You don't need full height, 7mm should be enough, cut or just screw it until…
I created this cable housing to hide the wires coming in and out of the skurup light. It is in the middle of a chain and thus has wires coming in and out of the fixture. To hide these i created a shell with a lid, that you screw in with…
The original lamp has a very light soft material on the base that prevents it from scratching the table. This wears out very fast. The previous install tinted my wooden table, so after I painted it black, I created this plastic cap to…
Printed in PET-GF for durability and to visually blend with other parts of the lamp.
I tried to clip the lamp onto a shelf that was juuuuuuust too big (5cm) for the clip to not slide off. Found this nice looking clamp model, and decided to use it as a base for a new mounting solution. DISCLAIMER: You will need to cut off…
A thin lamp shade that creates more indirect lighting on the ceiling. Fits on a IKEA SKURUP
Grab your T clips from here: https://www.printables.com/model/256896-skadis-t-clip-system
For all those who, like me, use the IKEA SKURUP work/wall lamp, black and, like me, no longer have the corresponding wall mount, here is a possible solution. Dimensions: Diameter: 70mm Total height: 20mm Height of the plate: 5mm Height of…
Model to turn an Ikea Skurup Lamp (https://www.ikea.com/de/de/p/skurup-klemmspot-schwarz-30489027/) into an wall-mounted lamp. Used it to fix my lamp with a broken clip. Requires disassembly of the original Ikea Skurup of a cutter and 4x…
This part is a replacement adapter for the IKEA Skurup track light. The original cable sleeve that comes with the lamp doesn’t always fit well – especially if the cable comes out of the ceiling at the wrong angle or the sleeve doesn’t sit…
Printed in PET-GF for durability and to visually blend with other parts of the lamp.
I tried to clip the lamp onto a shelf that was juuuuuuust too big (5cm) for the clip to not slide off. Found this nice looking clamp model, and decided to use it as a base for a new mounting solution. DISCLAIMER: You will need to cut off…
This is a basic model to repair an Ikea SKURUP work lamp. It works by clamping the rods in the 3D printed halves, and then with a 3D printed screws and the profile on the inside, the angle of the joint is easily adjustable. I printed…
A clip i made to hold my headphone in place when not in use on the Ikea desk lamp SKURUP
