Counting matching models…
Bumper for the gotcha evolve, complete with keyring hole. Printed in TPU, it fits great and is easy to remove for charging. It took a lot of time to design and prototype this, so if you like it a donation would be nice. Print settings:…
The model was modified by extending the top part to fully cover the lighter, eliminating the previous gap.
Here is a model I made for my Yashica camera. The cavity is based on the maximum published diameter of the battery, so one at the lower tolerance may wiggle a bit. Use a spring from a pen to bridge the gap of the contacts. Make sure you…
This is a remix of: https://makerworld.com/en/models/633256-dune-imperium-uprises-boxes?from=search#profileId-558336 I added a few boxes: Intrigue cards Command skills Sardauker meeples (fits on top of commander skills) Tech tiles Smaller…
The model was modified by extending the top part to fully cover the lighter, eliminating the previous gap.
Renault gear shift knob compatible with some cars like Duster, Logan, Sandero, and others. It worked on the Duster, but I think the fit could be improved a bit. It fit with some force. It is included fusion file. Made um PETG so far so…
This is a simple practical design. It is a cover to protect my 10kmAmp Anker Power bank. The size might be slightly different for a different model. It is 2mm think on all sides. Easily inserted, fully protected, accessible, and easily…
For my ebike I needed a light switch to turn lights on. Lower side is sealed with shrinking tube and hot glue. This is upper side. The final version here was surface smoothed with a heat gun. Printed in TPU with a stock. i3mega
Just a simple sleave/case for storing a Bic lighter so that the button can't be inadvertently pressed. Stinks to think you have a lighter until you need it and find out you really only have a striker. Good for emergency kits, or full on…
These knives are really sharp and I always worry about getting stabbed when I put them away in their original holders. I made this simple cover to replace the original. It is much safer. It prints in vase mode, 0.2mm layer height. I found…
