Counting matching models…
This is a display holder for the 3.2" LCD used for the JK Inverter BMS(also other JK BMS's) for the Lifepo4 cases. It fits the screen location used in most battery boxes. i used it to fit the JK inverter BMs and added the screen 3.2 LCD…
I added the cap as a separate .3mf I find it's not needed mind you. unless you plan on shaking and flipping the q-box. There's two caps in it. One is original, I find its too small (fractionally) and just rests in the hole, tho nearly…
Print the CCHolder in PLA, I printed in .2 layerheight. Print the “lids” in flex. In the bottom of the lids, cover with super glue before stretching on the sides of the main credit card holder.
SDS drill negative with snaps to cut away your desired shape and holders it stays upside down and you can shake it
SDS drill negative with snaps to cut away your desired shape and holders it stays upside down and you can shake it
This is a display holder for the 3.2" LCD used for the JK Inverter BMS(also other JK BMS's) for the Lifepo4 cases. It fits the screen location used in most battery boxes. i used it to fit the JK inverter BMs and added the screen 3.2 LCD…
Created with OpenScad remixed from: 10 mm Mid Thread, Flat Head, Bolt https://thangs.com/designer/Multiboard/3d-model/10%2520mm%2520Mid%2520Thread%252C%2520Flat%2520Head%252C%2520Bolt-973845 further information:…
Simple holder, printed in 20% infill structural, snapin fits good with a little wiggle so it doesnt break.
