Ender 5 feet (and sovolSV05)
hot tip.. you can gain 20mm in Z by moving the motor bracket underneath the profile
- Downloads
- 384
- Likes
- 60
- Rating
- 5
Counting matching models…
hot tip.. you can gain 20mm in Z by moving the motor bracket underneath the profile
The Sovol SV06 faces a challenge in which prints with frequent retractions tend to fail due to clogged nozzles. This issue is caused by heat creep, as the heat dissipation is inadequate. To resolve this problem, the following steps are…
Filament runout sensor cable holder for the top bar. Includes insert for 8x2 magnets, though they are not required. I recommend printint out of TPU.
Filament runout sensor cable holder for the top bar. Includes insert for 8x2 magnets, though they are not required. I recommend printint out of TPU.
I made this simple pulley that allows yout to feed filament into the printer from below, might not work with really stiff filaments. I tried pla and asa so far and they work fine. Please note that when installed it reduces the z height by…