Counting matching models…
Print the Oddball.stl twice with the flat side down and two Oddball_Merger.stl. For best results, use a layer height lower than 0.2mm, even though 0.2 works as well. No support required. Use a little superglue to put the two halves…
Introducing the worlds smallest spikeball set! You can use for a fun little toy or use it for a display stand or your desk or table! You will only need to use sopports for the ball! You can use it for a fun little toy or you can use it…
My roundnet(spikeball clone) broke where its inserted into the legs. So i modelled a piece that can be glued on. Theres a couple different ones. The v1 broke after some games due to small wall taking the load. The new versions has a…
A simple replacement adapter in case the plastic connection between ball pump head and tube broke. Print upright, maybe add a brim. I didn't add the air release valve as its not really necessary. In case you pump too much air into the…
Roundnet Replacement Leg One of the legs broke on a Decathlon Roundnet/Spike ball kit (https://www.decathlon.com.au/p/roundnet-set-recycled-black-kipsta-8647739.html) after a friend fell on it. I designed this to replace it. I tried to…
Spikeball logo, with and without a recess for a magnet, slice it with a filament change for two color printing. Use a 6x2mm magnet if desired.
The pin will hold if you just stick it in, but I would prefer to glue the printed part into the bottom part.
This is a small Spikeball logo key fob. It prints quickly and easily. It is quite durable. I like to use PETG for this model.
A replacement hook for a cheap Spikeball/roundnet set. I designed this because the original hooks wore out and started slipping around the ring.
Here is a simple little stand for holding a Spikeball! It only takes about 20 min. to print! It makes a good stand for displaying your ball on your desk or table! It fits the ball perfectly on the stand! Have fun tinkering and printing!
A simple way to hold up to 10 Spikeballs around your net while you play. No Hardware is required!
Good for removing mineral deposits without abrasives. The close bristle spacing reduces vibration. This is sized for a 3/8" (10 mm) chuck.
The pin will hold if you just stick it in, but I would prefer to glue the printed part into the bottom part.
Print the Oddball.stl twice with the flat side down and two Oddball_Merger.stl. For best results, use a layer height lower than 0.2mm, even though 0.2 works as well. No support required. Use a little superglue to put the two halves…
Good for removing mineral deposits without abrasives. The close bristle spacing reduces vibration. This is sized for a 3/8" (10 mm) chuck.
This is a small Spikeball logo key fob. It prints quickly and easily. It is quite durable. I like to use PETG for this model.
