6 models
This is a cap I made to cover a spinbrush electric toothbrush. You could scale it for any toothbrush. The inside width is 12.7mm. If you need to scale it to your toothbrush, I'd scale it to 0.2mm smaller than the width of your toothbrush…
SpinBrush pro ToothBrush Holder stand i made
I need a holder to put all the toothbrushes we have. so, I created this fun little holder with a fun saying on it. No supports needed. Print at .16 layer height for best results. Connect the main base to the back with M4 (4MM) screws. Are…
This is a great holder for your generic Spinbrush from walmart. I put it on my wall with a Command strip. A like would be nice! Category: 3D Printing
This is a stand for the new versions of the Spinbrush Pro Clean with a more square shaped bottom. I first saw the new toothbrush version around 2025. There are two versions of the model, one with a drain hole and one without. Double-check…
Stand to hold toothbrush facing down. I had one of these brushes fail, when I took it apart to see what went bad found the on/off switch improperly soldered to the circuit board. Also noted that the top of the motor was corroded. The…
