Counting matching models…
This is my prototype for a 3D printable top-mounted vibrato/whammy bar system for guitars, inspired by the Bigsby design. Requires a spring about 1 cm wide to operate. Drill holes of desired screw size in the base to mount. This is a work…
This is my prototype for a 3D printable top-mounted vibrato/whammy bar system for guitars, inspired by the Bigsby design. Requires a spring about 1 cm wide to operate. Drill holes of desired screw size in the base to mount. This is a work…
I was looking at the hardware store for a small adapter for my dishwasher to connect to a new drain tailpiece. the old one had a different dimension than the replacement. rather than fudging with an overpriced piece of hose, I went back…
Our bathroom tailpiece broke off and I made replacement. I tighten it by hand. Printed from ASA, but I think that any material except PLA would be ok. Print profile 0.3 mm - draft, perimeters set to 3. Printing time is approx. 3 hours.
I needed this tailpiece to mount my new topper handles since the originals broke. Printed at 0.3mm height with 100% infill in PETG.
It holds the spring loaded pin down and uses the rest of the indentations to spin the cap.
You can change the parametric Fusion 360 model to configure it for your musical instrument. Instead of a high infill, please use a wall thickness of 3. Then it's enough to have 10% to 20% infill. PLA+ is ok for the model, but please add a…
Seat bar tailpiece for Peugeot Expert Traveller, Citroen Spacetourer and Toyota Proace. The original broke fairly easily. To remove the bar from under the seat, it is necessary to apply adequate force (the bar is springy) and to remove…
