Counting matching models…
This is a minimal case for a IR sensor (Reflective Optical Sensor TCRT5000). The sensor dimension are approximately 30x14mm sensor fits inside the case without the need of screwing or fixing in any other ways, but a screw hole is present…
This is a model of a tcrt5000 infrared sensor
These are the enclosures I designed for the DIY-Sensor for a Ferraris wheel power counter with an Amica NodeMCU ESP8266. You can read details on the setup and build and get the software at…
A compact infrared reflective sensor for fischertechnik, based on the TCRT5000 reflective optical sensor with transistor output . I needed them for a line-following robot. Use an analog input pin to measure the signal (sensor out pin).…
Inspired by this model: https://www.thingiverse.com/thing:6088290 But didn't need the housing to fit a ESP module. Also had issues with light reflecting on the window and always giving a high reading. I've integrated good seperation of…
I designed this model for a robotics competition because I needed a sensor array but only had individual sensors on hand. I then modeled a small enclosure for three equally spaced at 5mm. When loading the file to your preferred slicer,…
If you have a eHZ Generation K energy meter, you can use this print to hold a TCRT5000 to it using a magnet press-fitted into it. The hole for the led is covered so you don't have to desolder it. With this, you can read the data using…
DOES NOT WORK STABLE TROUGH GLASS YET, DO NOT USE IT, JUST FOR TESTING. (Maybe it is working with an aluminium surface.) 2016.09.30. With this position I can't setup it correctly :( Feel free to post your idea. At the first place where I…
I moved the connecting rings for the fixing screws to fit my robot compared to the original which had them on top and created the right and left version
When loading the file to your preferred slicer, you may receive a request to “repair” the model. This is due to a small extrusion at the base that allows the print to be printed at a small elevation with the help of supports. Do not…
I moved the connecting rings for the fixing screws to fit my robot compared to the original which had them on top and created the right and left version
The back plate can be mounted with M3 or M2 screws. There are two holes in the back for the status LEDs. Have fun.
I love the TCRT5000 Reflective Optical Sensor. It's cheap and very easy to use in my arduino projects. I created a mount to fixate the infrared LED and the infrared detector and to isolate and guide the pins to solder points where I…
