Counting matching models…
Very grateful to MTMscad for his original, I modified it to perfectly fit the Tecsun PL-330 receiver and added a cutaway (circled in red) to allow the volume knob to turn freely.
Not much to say, the desk stand keeps the radio at a nice angle and the knob lets you tune faster by cranking. The desk stand should be printed on end for strength. The cuts are at a steep enough angle to print without supports. You may…
This is a puck stand for the Tecsun PL-368 and County Comm GP-7 radios. This stand features a lower cut front to match the lower speaker location of these new radios. The older versions of these radios had the speaker located higher on…
This is actrally my first 3D print design model, simple and work.
I just made a new stand for the radio, which improve the stability, and also can be used as a protective case. No support needed.
Made this model after trying KB9RLW's since his version doesn't fit newer Tecsun PL330 models. In case your printer is calibrated to print slightly larger (like mine), I also provide a tight version.
It's a stand for a radio
Designed intentionally with snug fit With 0.4 mm nozzle 0.2 mm layer height Supports required
Modified version of Silviu's model that incorporates a wider base for further stability. I have additionally added countersunk holes that can be used to screw / stake down the radio base in order to provide more flexible mounting options.…
Designed intentionally with snug fit With 0.4 mm nozzle 0.2 mm layer height Requires a tiny bit of support but may also print fine without any supports
case insert for the tecsun pl310-et
Radio Support for TECSUN PL-880 for better ergonomy. Additionally this is sturdier than fold-out support on the radio that is prone of breaking easily. A slightly lower angle allows vertical position of antenna.
Desktop stand for S-8800 model radio. Has relief holes for usb power cable, antenna and external audio jacks.
Simple stand for the Tecsun Pl-368 with a built in storage for the AM antenna. Insipired by: for dimensions and holder - https://www.thingiverse.com/thing:4371146 and for the layout - https://www.thingiverse.com/thing:5296825
A small hat to prevent the antenna too folded in and cannot be take out.
