Counting matching models…
This is a remix of Szymon's excellent model. All I did was make it one piece, since it will take the USB plug diagonally and you can just push it in then. No screws necessary.
A remix of my prior USB receiver attachment with wider holes allowing for a narrower metal loop.
I added a thicker bottom / back, widened the clippy bit and put a bigger circle on it and placed a hole in it for a keyring to go through it the keyring helps act as a stop to prevent the dongle slipping out, also any movement / swinging…
This is a simple framework expansion card adapter for the newer Logitech Unifying receiver. Print vertically in two pieces with minimal infill – 0.20 mm layer and 15% should work just fine. You will need: - A USB-C to USB-A slim adapter…
LOGITECH UNIFYING RECEIVER PROTECTION BOX since it does come without any Category: Computer
I bought a Logitech MX Master and was dismayed that there was no on-device storage for the Unifying Receiver. Ultimately, I purchased a zipper case for the mouse and decided to make a holder for the receiver. This should be printed in TPU…
I image a lot of machines, then ship them out. This clip allows me to attach a keyring to the USB so I never again forget to remove it.
Logitech unifying repair case. Category: Other
My computer is docked too far from my mouse for the Unifying receiver to get a reliable signal. This cap puts the receiver on a USB extension right at the desk surface, pointing at the mouse, without an extra dongle lying on the desk. It…
I image a lot of machines, then ship them out. This clip allows me to attach a keyring to the USB so I never again forget to remove it.
We wanted to attach these keyrings to USB receivers at work so they wouldn't get lost or forgotten. These attachments allow doing so without any adhesives or damaging the receiver.
