Counting matching models…
good tumbler 70mm fan with nut in one blade Print Settings Printer: FlyingBear Ghost 4S Supports: Doesn't Matter Resolution: 0.2 Infill: 25% Filament: none PLA RED Notes: I used red fillament because I don`t have black filament at this…
If required, the adapter can be fixed with an indicated screw hole. Thanks for Hobbyhimmel for inventing this system: https://www.ossso.de/osvac/
I found that my Hornady vibratory trickler worked a lot better when tilted slightly and needed to be elevated to work with my scale and not get in the way. This stand tilts it 4deg and lifts it approximately 10mm on the left side. I added…
Replacement for the original rubber vibration isolation feet. This print makes use of the original hardware including the nut that is glued inside. Part dimensions should be close enough to allow replacing of only one foot as needed but…
NOTE print at 101% or higher if your printer cant print tight tollerances. For me its a super snug fit, if you have “perfect” non bulbous corners General purpose vibratory base for anything thats 38x38. I use it for moulds for high temp…
this model uses two interlocking A brackets coupled with a string through a center hole to allow the printer to "jiggle" freely, the model includes brackets to affix to aluminum extrusion and additional brackets to tape to a table,…
