Counting matching models…
The power supply that came with my Ratrig kit did not have any mounting feet. This is the missing mounting foot. I left the angle clip a little big so it would be snug. This required me to trim off a bit to make it fit, so some manual…
Print approx. €0.40–€0.49 excl. taxPreliminary estimate for one variant
DIN rail mount and terminal cover for the WEHO LRS-250 PSU. (might fit other models, Meanwell LRS-200 series seems to have the same dimensions). Terminal cover can be opened without tools. Prints without supports. Printed in PETG at layer…
Slotted hole to somewhat adjust the mounting height of the power supply.
I wanted to mount my Weho PSU vertically on the din rails in my RatRig V-Core 3.1 300. Therefore I created this model, mounts on a single din rail (second from the bottom in the picture). Requires 4 short screws that fit into the PSU Back…
Wanted a cover for my Weho S-400-24 power supply, which also would allow me to install one or more XT-60 connectors to connect it to my drone battery chargers. Since I didn't find anything matching my needs online I took an existing…
This is a bracket for mounting a WEHO WRS-250 power supply unit onto metal DIN rail clips like these here: https://de.aliexpress.com/item/32971006389.html This is for mounting the PSU in landscape orientation onto a DIN rail. You need to…
It is a holder for the WEHO psu. Because of the length of the PSU you will need to print the shortened Idler holder and motor cage.
I was too lazy to unscrew the ring terminals so I remixed this file instead 💀
Retainer for holding down the U.FL/IPEX connectors on the wehoop4 915MHz BPF. Needs M2.5 machine screws. I would recommend M2.5x6, but M2.5x8 (what I used in picture) works fine too.
Case for a Wehooper4 XiaoGator Lite . Fits a 3000 mAh flat LiPo battery and a power switch . You'll need some screws: 4x M2.5 screws for the standoffs 2x M2 screws for the switch 4x M3 screws for the corner screws Designed with Claude…
Retainer for holding down the U.FL/IPEX connectors on the wehoop4 915MHz BPF. Needs M2.5 machine screws. I would recommend M2.5x6, but M2.5x8 (what I used in picture) works fine too.
Mount and high voltage protector for ratrig weho power supply.
