Counting matching models…
(Have a look at the ‘ Stable glider V5 ’ It should glide much better.) Differences: Added Winglets and a rudder, also scaled down to 140mm so the model is quicker to iterate and print. Changes made: Thinning two channels on the wingtips…
two winglets for LIDL glider version2 They fit perfectly to the tips of the wings and do not prevent (pre cut) ailerons to move. To get enough strength I printed them with 2 perimeters, 0% infill, 0 bottom layer and 0 top layers Note that…
This is a reprint of the Wheel hubs on the car which now include the winglets seen over the front tires of the 2022 F1 cars. Original Files from Daniel Noree Follow along for more updates to the 2022 F1 Car
Added screwholes and made the trailing edge flat for printing in one piece. For other side just mirror it. Should be about 25g Print settings: 0.2 layers with 1 wall 5% infill use brim if required material: pla no supports needed
This is the winglet, and a hook for bungee launching, for the TBS Caipirinha 2. The winglets are an exact replica of the coroplast winglets in the kit, but with sealed edges and more strength. They only weigh 5 grams more than the…
Windshield side winglets can give a bit an optimised stream of air since the BT1100 windshield is somehow narrow at the top. These are specifically done for 4.5 mm-thick windshield that is curved in two directions. There are three size to…
Replacement parts for the FT Spear. The winglets are slightly smaller than the original ones. I've flown many rounds now with these on and the winglets didn't break yet :-) Category: 3D Printing
Winglets for the FT Spear - Wing tips, with blister for internal LED. Winglets are not interchangeable - there is a left and a right. Blister is, so print two.
print as is, supports needed but if it says this model needs to be fixed use the fixing software (im pretty sure this is only on bambu printers) than use the fixer. also no photos bc i dont have a camera :(
Windshield side winglets can give a bit an optimised stream of air since the BT1100 windshield is somehow narrow at the top. These are specifically done for 4.5 mm-thick windshield that is curved in two directions. There are three size to…
Ducati Monster Winglets im v4r design you musst mirror the Wing for the Left side and need 4 M6 Screws and Mothers
I like to practise stunt flying with my sacrificial foamy and in doing so, many of the original accesories I had have been broken or lost, therefor I spent a bit of time remodeling them so I can reprint them as many times as I need, and…
