9 models
This is a quick design I came up with for wingtip armor for the HobbyZone Aeroscout. As a new, inexperienced pilot, I kept scuffing the wingtips of my AeroScout during landings. They aren't a perfect fit and won't keep the aircraft…
Print your own 1:516 scale model of the XB-70 Valkyrie, one of the most ambitious bombers ever built! Designed to fly at Mach 3 while soaring at 70,000 feet, the XB-70 featured a sleek delta-wing shape and innovative folding wingtips to…
light, when printed at 15-20 percent infill. two halves, ca glued together scale to fit your wingtips.
These are a set of wingtip light mounts for a Sonex aircraft. Two variants are included - one for Whelen Orion lights and one for AeroLed Pulsar NXP lights. They have not yet been tested on a flying vehicle, but they should have the…
20250531UPDATE: Sand the upper part of the rear bump a little if fitting difficulty is encountered. INTRODUCTION Basically, a wingtip, and a shorter one compared to the kit. Out of my unwillingness of finding places for the thick ones…
Mirror for left and right
Detachable winglets for the FPV wing Reptile S800. I didn't fancy using the integrated nuts and bolts one as it seemed like added weight and complexity so I thought I'd go and make my own entirely 3D printed. Each side weighs about 8g…
This is a set of wing tips for the Destiny ghost by BoldPrintShop. This allows you to print the ghost to look like the Iron Ghost Shell from Rise of Iron Print Settings Rafts: No Supports: No Resolution: 0.18 or below Infill: 15%
Thin shell LED light holder to make a wingtip navigation and strobe lights assembly for radio control aircraft. Fits 3 standard 5 mm diameter LEDs. I'm using this ( https://www.amazon.com/dp/B0C6V1PYZS ) lights kit. Prints without…
