Counting matching models…
Repaired mesh iteratively in meshlab so prusa slicer could print it. Will update with photo of print once it is done. Category: Scans & Replicas Note : should print fine in Prusa Slicer after error correction. May not print in certain…
⚙ RECOMMENDED 3D PRINT SETTINGS Material: PLA or PLA+ recommended Layer Height: 0.16 mm for finer detail; 0.20 mm for faster prints Infill: 10–15% recommended for most models Wall Loops: 2–3 Supports: Enable where necessary based on model…
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Transmission Distance: 4 PLA BambuLab Basic Yellow Transmission…
Wizardry Night is a night full of magic spells, foggy road, smell of freshly made poison from the witch kettle.
Jedná se o náhradu k papírovému hradu z dětské deskové hry Tajná výprava čarodějů. Hrad by měl být podobný k papírové předloze, má i podobné rozměry tak, aby mohl být umístěn na hrací desku. K dispozici jsou dvě varianty. Celý hrad a…
