1 / 2
Router bit holder — zdjęcie 1
1 / 2

Router bit holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Router bit holder for 1/4" and 1/2" shank bits. Fits into a 5/8" hole for 3/4" plywood.

Ocena
4,25 / 5
Polubienia
107
Pobrania
595
Wydruki
4
Wyświetlenia
3419
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

Router bit holder capable of holding both ¼" and ½" shank bits. It's designed to fit into a 5/8" hole that's been drilled into plywood or other material. Fits somewhat snug in ¾" plywood but you could probably glue it in place. Hole in bottom helps prevent build-up of sawdust in holder.

Note: Tested fit is slightly loose so you don't run the risk of slicing open your fingers while trying to pull out something like a straight/mortising bit. So, don't try to use it to hold bits horizontally.

Print at 0.2 mm height, 15% infill. Be sure to orient upside down so you can print without any needed supports.