Router bit holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Router bit holder for 1/4" and 1/2" shank bits. Fits into a 5/8" hole for 3/4" plywood.
- Rating
- 4.25 / 5
- Likes
- 107
- Downloads
- 595
- Makes
- 4
- Views
- 3,419
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Router bit holder capable of holding both ¼" and ½" shank bits. It's designed to fit into a 5/8" hole that's been drilled into plywood or other material. Fits somewhat snug in ¾" plywood but you could probably glue it in place. Hole in bottom helps prevent build-up of sawdust in holder.
Note: Tested fit is slightly loose so you don't run the risk of slicing open your fingers while trying to pull out something like a straight/mortising bit. So, don't try to use it to hold bits horizontally.
Print at 0.2 mm height, 15% infill. Be sure to orient upside down so you can print without any needed supports.