Paper Towel roll holder for 3/4" wire shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A paper towel holder for a wire shelf system with 3/4" diameter corner columns, plus some mods for the original version.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 248
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I printed NotLikeALeafOnTheWind's version before realizing that I did not have 1" shelving! Mine was 3/4 inch. I printed an adapter to accommodate the smaller size but the bottom arm would droop somewhat. I also experimented splitting the barrels ("knobs") that sit inside each end of the towel tube into two pieces to adapt better to tightening forces that would prevent it from inadvertently unscrewing during use. These STLs are provided in case they serve your purposes.
Ultimately, I scaled down the original and padded the clip feature to be 2mm thick, which provides a good connection to the shelving. Since the paper towel rolls we have are not extremely bulky, the shorter reach of the arms isn't a problem. I have embossed an arrow near the threads to indicate their direction. I suggest you print one regular and one mirrored version for top and bottom, then orient them such that any friction of pulling the roll will act to tighten each side.