1 / 3
Paper Towel roll holder for 3/4" wire shelf — image 1
1 / 3

Paper Towel roll holder for 3/4" wire shelf

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A paper towel holder for a wire shelf system with 3/4" diameter corner columns, plus some mods for the original version.

Rating
0 / 5
Likes
14
Downloads
34
Makes
0
Views
251
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I printed NotLikeALeafOnTheWind's version before realizing that I did not have 1" shelving!  Mine was 3/4 inch.  I printed an adapter to accommodate the smaller size but the bottom arm would droop somewhat.  I also experimented splitting the barrels ("knobs") that sit inside each end of the towel tube into two pieces to adapt better to tightening forces that would prevent it from inadvertently unscrewing during use.  These STLs are provided in case they serve your purposes.

Ultimately, I scaled down the original and padded the clip feature to be 2mm thick, which provides a good connection to the shelving.  Since the paper towel rolls we have are not extremely bulky, the shorter reach of the arms isn't a problem.  I have embossed an arrow near the threads to indicate their direction.  I suggest you print one regular and one mirrored version for top and bottom, then orient them such that any friction of pulling the roll will act to tighten each side.

 

Tags