Christmas Tree Stand Improvements
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Got tired of having to deal with poorly design Christmas Tree Stands so I decided to make some improvements to an old…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 1
- Wyświetlenia
- 74
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Share Alike
Got tired of having to deal with poorly design Christmas Tree Stands so I decided to make some improvements to an old commercial unit I had kicking around. My stand originally consisted of four L-shaped bolts to secure to the tree trunk. The bolt side facing the trunk would dig into the tree as you tightened the bolts. As a result, the tree clamping never became super tight (sponge like effect) and would loosen up as the tree settled in & began to dry up. It was also very difficult to get a good torque on the bolts due to the short 2” L-shaped portion of the bolt. Unfortunately, there wasn’t much to grab onto & it would often hurt your hand when trying to get them really tight.
Print Settings
Printer Brand: Prusa
Printer: i3 MK2S
Rafts: No
Supports: Doesn't Matter
Resolution: 0.15mm OPTIMAL
Infill: 50%
Filament: Doesn't matter
Filament Type: ABS
Filament Color: Doesn't matter
Special Notes:
The design is for 5/16 inch bolts. Resize the design to accommodate different bolt sizes.
Description of the improvements:
Added buttons at the tree end of the bolts to better clamp the tree trunk. The trunk buttons help in two ways: 1) they provide a larger surface area thus improving retention; 2) they don’t dig into the tree so are able to provide a consistent, reliable & secure hold.
The second improvement was to add larger grip handles at the L-portion of the bolts. This greatly facilitates tightening the bolts by hand.
Category: Decor