Fast Pinball Playfield IO Vertical Board Mount (1616 3208 0804 Node Boards)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made these for mounting the Fast Pinball IO Node Boards. There is a short and a full height version.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I made this version to support vertical mounting of the IO Node boards from Fast Pinball.
The regular version is full height, with a cut out so you can see the status and to avoid some of the surface mount components along the left edge. However, this means that you cannot slide the card in from the top, without loosening the screws holding the bottom to the playfield. tradeoffs! I made the slot tight, so that when the screws tighten, they don't break the plastic.
The short version is half-height, but plenty strong enough to hold the board securely. Plus, it allows the card to be slid up and out without removing the mount from the playfield.
I use M4 screws to join the board to the mount. But a #6 wood/metal sheet screw will work too. To join the mount to the playfield, use #6 or similar.
Providing STEP files. Here's the onshape reference too: https://cad.onshape.com/documents/caefef1332072fb862d7089a/w/a9232eba1a7ccbd79e00f915/e/3420f0c6a638b45a503e32ad
Printing: I've printed in PLA and ASA - both work. Orient the model laying down on its back, with the outer spine down on the bed, and with the card slot facing upwards. You can mirror the left, or use the mirrored “right” copy provided - if you want mounting screws on the same side - else one size fits all.