Original Prusa Enclosure Lid Prop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows the Prusa Enclosure Lid to be held open, and you can work with out the lid getting in your way.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 310
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- GNU General Public License v2.0
I needed a way to hold the lid open when working by myself. Due to my setup, I can't open the lid the way it's probably meant to, so I have to have someone hold it while I'm working in from the top or have the lid sit on my head/back. Sometimes someone isn't always available to help me and it makes it hard to do certain things when I need to use both of my hands and hold the lid up on my head. So I created this! I had other versions in mind, but none of them worked out and they were causing me to use and then therefore waste a lot of filament. I used a piece of PVC pipe that I cut to roughly 22.5in (or 57.15 cm) then I cut a slant at each end. The top was originally meant to sit on the lid/handle , but that didn't work, however using it on the handle itself worked just as well.
PLA
0.2 Speed
No Supports - (flip the models so they sit on correct faces. I added a picture that will hopefully help)
15% infill