Kong dog toy holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Meant for holding the kong toy vertical in my freezer
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 532
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
This is meant for the kong toys that are about 80mm tall but it probably scales down perfectly to fit the smaller ones.
Two bodies in single step file. Use prusa slic3r or similar to split into objects and slice as needed.
Two parts, print orientation should be obvious.
I used ABS because that's what I had loaded but material, resolution/layer height are not super critical here.
I used a few drops of super glue to attach the nozzle support arm to the main body and let it cure before mounting in my freezer.
The flat part meant to adhere the part to the mounting surface is 13mm tall which should allow for both 10mm and ½ inch size double stick tape. I used ~4cm of VHB tape to attach these into my freezer door.