Miniature magnet applicator

Struggling with inserting these miniature magnets into your prints?

Worry no more as from now on you will have full control over the little pesky things; including the orientation!

Magnets used are 3mm diameter 2mm height: https://www.amazon.de/-/en/gp/product/B0CBP8LGZC/

My favorite tool for inserting the magnets so far was: https://makerworld.com/en/models/629168

Please keep in mind:

• initial layer - 0.2mm
• layer height - 0.1mm
• print on separate plates to get Blue/Red
• correct orientation of the magnets is critical
• pause the printer before printing the ceiling for magnet compartment - that would be perfect time to insert your magnets
• no brim required as inserted magnets will take care of holding to the plate
• no worries about magnets sticking to the nozzle - proximity of the print plate keeps them from popping out :)