Cooling Duct for SilverStone D380
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Improves the cooling of hard disk drives installed in the SilverStone DS380 case by 10-15 degrees Celsius!
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 424
- Wydruki
- 2
- Wyświetlenia
- 2941
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
In the building of my DIY NAS: 2017 Edition using the SilverStone DS380 case, I noticed that my hard disk drive temperatures were running a few degrees higher than I was comfortable with.
I wound up reading a FreeNAS forum post describing blocking an air gap at the bottom of the case's drive cage and asked myself "Why not design a duct that screws into the case's 120mm cooling fans?"
After a few minutes with my calipers, a few revisions later, and after stamping my face on the thing, I had a closed the majority of the SilverStone DS380's air gap with the duct.
No 3D Printer? No problem! I am selling the Cooling Duct for SilverStone DS380 on eBay for quite a bit cheaper than the few 3D printing services I compared it to.