Cooling Duct for SilverStone D380
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Improves the cooling of hard disk drives installed in the SilverStone DS380 case by 10-15 degrees Celsius!
- Rating
- 5 / 5
- Likes
- 18
- Downloads
- 424
- Makes
- 2
- Views
- 2,941
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
In the building of my DIY NAS: 2017 Edition using the SilverStone DS380 case, I noticed that my hard disk drive temperatures were running a few degrees higher than I was comfortable with.
I wound up reading a FreeNAS forum post describing blocking an air gap at the bottom of the case's drive cage and asked myself "Why not design a duct that screws into the case's 120mm cooling fans?"
After a few minutes with my calipers, a few revisions later, and after stamping my face on the thing, I had a closed the majority of the SilverStone DS380's air gap with the duct.
No 3D Printer? No problem! I am selling the Cooling Duct for SilverStone DS380 on eBay for quite a bit cheaper than the few 3D printing services I compared it to.