GeeekPi 10 in rack shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shelf v1 is 4mm thick, which may have been too thick.Shelf v2 is 2mm thick, and made the mounting holes slightly…
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 243
- Wydruki
- 0
- Wyświetlenia
- 2869
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Shelf v1 is 4mm thick, which may have been too thick. Shelf v2 is 2mm thick, and made the mounting holes slightly smaller to allow more material for structural integrity
Both are pictured in the rack. I included the F3D files if you want to modify.
Bracket v1 matches the hole setup of shelf v1 Bracket v2 matches the hole setup of shelf v2
4x M6 screws, washers, & lock nuts are needed to attach the bracket to the rear of the rack and shelf.
Print Settings
Printer Brand:
ELEGOO
Printer:
ELEGOO NEPTUNE 4 Max
No
Supports:
No
0.2mm layer height with 0.4mm nozzle
Infill:
15%
Notes:
4 walls
alternating walls enabled
Inner/Outer/Inner
5 bottom layers
5 top layers
15% infill with gyroid (base ends up being solid at 2mm with 0.2mm layer height)
I measured the rack itself to design the dimensions of the shelf.
Category: Electronics