1 / 5
PTFE Tube Hose guide for MMU2 LACK enclosure with a door to open — zdjęcie 1
1 / 5

PTFE Tube Hose guide for MMU2 LACK enclosure with a door to open

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

this is a remix of my PTFE hose guide for my MMU2 LACK enclosure with a small door to have access to the MMU2

Ocena
0 / 5
Polubienia
12
Pobrania
22
Wydruki
0
Wyświetlenia
1161
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

For the assembly you need the following things:
16x M3x10 screws
2x M3 nuts
for the door a 133x95x4mm plexiglass / or you can use the 3 mm plexi from the cutout if it is still usable ...
5x PC4-M10 fittings
2x 10x2 round magnets

For the assembly you first take the spacer and mark the 10 holes (3 to 3.5mm), which are visible from the semicircular notches. After you have drilled the holes, you can stop the spacer nicely and mark the cutout from the back wall. The cutout will be around 154x110mm. Then you can mount the front plate with the spacer and the back plate with a few screws and thus mark and drill the remaining 4 holes for the screws and the 5 holes (approx. 4.5mm) for the PTFE tubes.
When that's done, you can assemble the door. For this purpose, the 4mm thick plexiglass is inserted into the door front and clipped firmly with the doorback. The door is designed for a 4mm plexiglass because I had it lying around, but it is certainly possible to use the 3mm plexiglass from the cutout. The door_back file is attached in a 3mm and 4mm version. Then the two M3 nuts are inserted into the back plate by the hinges and the door is fixed with two M3x10 screws. To keep the door nicely closed, put a 10x2 round magnet into the two slots provided in the door and the back panel. Screw in the 5 PC4-M10 fittings and finally assemble everything.

I hope you will find it useful too, have fun with it :)

Tagi