Diamond stone case for 8" x 3" set (205mmx80mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for holding 2x diamond stones and a strop. Also fixture for holding the stone in place. Includes ventilation holes.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 188
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Got tired of getting sawdust on my stones. Designed to fit a set of diamond stones that are 8x3x0.3", or 205x80x8mm. I also have a strop the same size that I glued onto a piece of 3/8" ply, so the top slot is slightly taller (14mm). It also doesn't need the ventilation.
There's a tiny nub that makes it so they won't slide out when you don't want, and some thumb cut-outs for when you do.
Designed to print vertically, on-end, but you could probably print at a 45* angle if you support it.
The top tray holds the stone in place when in use. I haven't had any problems using it as is, if you find it slips you could put some rubber pads on the bottom.