V2 - S400 Mini-ITX Case - (Inspired by FormD) Vertical Stand

V2 version, this one fits much nicer and is much easier to put on and off the case. The previous one was a very snug fit whereas this one, while still not being a lose fit, doesn't feel like you're going to pull the paint off the case.

I have printed this myself and works perfectly. I printed the 100mm version because I do not have a right angle power cable

This is a vertical stand for the S400. I could see a few for the S300 but decided I'd just make my own one for the S400 case as well. The vertical stand saves even more space on the desk than what this tiny PC case already saves in terms of surface area and all the cables will be hidden by the stand. It will increase the height profile.

I have also attached some test prints for you to try out rather than printing the whole thing so you can see how well it fits yours and scale it if necessary.

Printed on an Ender 3 V2 Neo.

Print takes up near enough the whole bed when printing on the Ender 3 V2 Neo.

Printed 'upside down' so that the feet face upwards off the print bed. Standard supports used in Cura.

I've printed this using PLA + with 15% infill on grid and seems to do the job. Cannot personally attest to less infill density resulting in similar durability. I feel like 15% is the lowest you can go so maybe if you wanted to be a bit more on the safer side I would go with around 30% or higher.

Despite having used PLA+ myself when printing this model, even when the computer is under serious loads I've not seen any deformation due to thermal elasticity. If you want to be on the safe side then perhaps printing in PETG or something more heat resistant is the way to go but again mine has been completely fine in PLA+ (approximately 10 days thus far with no signs of deformation).

It is a pretty snug fit to the PC case but I designed it this way on purpose as I would rather that and know that the PC isn't going to fall out of the thing!”