1 / 4
Coffee wall drawing in 4 parts for Prusa MINI — zdjęcie 1
1 / 4

Coffee wall drawing in 4 parts for Prusa MINI

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Coffee wall drawing remix for Prusa Mini scaled and cut into 4 pieces with snap connectors (37 cm width when assembled).

Ocena
0 / 5
Polubienia
5
Pobrania
31
Wydruki
0
Wyświetlenia
127
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Remix of the coffee wall drawing by AhmetAtalay_383956, tailored for the Prusa MINI. Total width is between 37 and 38 cm.

Tested with PLA.

Recommendations:
  • The model file contains all 4 parts with snap connector and/or corresponding holes. Mark one part as printable at a time and slice it, then proceed to the next part. You may scale down a little bit if you like.
  • Assemble the snap connectors using medium force before mounting to the wall.
  • Approx printing time (0.2 mm, 15 % cubic infill, 3 perimeters, no brims and no supports): 70 min + 110 min + 70 min + 40 min = 290 min (4 h 50 min, ca. 61 g filament).
  • No support structures needed. If you print with a skirt, it will slightly stick to the snap connectors, but can be removed easily.

Tagi