Pole Hooks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A coiled pole hook that slips easily into place.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I recommend printing in PLA+ or PETG. You will need just a little flex to put the hook into place on a pole. This is by design to ensure a good no-slip grip.
I printed in matte PLA which did work, but it cracked slight due to the stress.
My next print was PLA+ in 0.28mm layers with 4 walls and 30 infill. Perfect flex and fit!
Supports aren't strictly necessary, but I did have one misprint due to the very small bed contact area on the coil. I then used slim tree supports which prevented that issue. There were also tiny trees along the length of the hook body. I used a deburr tool and it cleaned up very well.
While this is strong enough to hold my dremel tool, I conceived it as a rag hook … I consider it light duty.